This is a discussion forum for members to showcase how their custom became a custom. Boats, Cars, Trucks, Houses.
Re: Shaft length advice for Bass boat my guess would be a 25 inch shaft. im not sure but since its a bass boat, it most likly has a short transom and therefore it needs a shorter shaft or a longer shaft with a jack plate. id go shorter but don't quote me on that...
Re: Boat taking on water Have you ran it and looked at all hoses etc? If it's not bellows, and it takes on water while on muffs, it certainly sounds like an engine cooling system issue. Hose, manifold (s), thermostat housing, fuel cooler (not sure on 4.3) etc. I think I'll move this to the Merc I/O section. Not sure how water entering hull on muffs could not be engine/drive related. This ...
ATAL BOAT COLLISION- LAKE HAVASU On Tuesday (4/7) at approximately 4:50 PM, Mohave County Sheriff's Office Division of Boating Safety Deputies were dispatched on the Colorado River near the Topock Gorge, north of Lake Havasu, in reference to a boating collision. Upon arrival, Deputies located a boat near the California Shoreline. Fire Boats from the San Bernardino County Fire Department and ...
Boat crash near Topac right now | Page 2 | River Daves Place
Re: Alumium Boat Seat Replacement~What type of wood? Yellow pine is strong and durable but nominal standard thickness is typically 3/4 inch or 1-1/2. Another suggestion that may work is using 5/4 pressure treated decking boards. They're strong with a bull nosed edge and depending on the width of your seat you'll need more than one. Typically they are 5-1/2" wide and 1-1/8" thick which may ...