I have a single car garage with a sectional overhead door, I have space on one stucco wall for a 24 x 75 pedestrian door. will that size be acceptable since it is not the main egress door?
2024 IRC R302.5.3 says "Penetrations through the separation required in Section R302.6 shall be protected as required by Section R302.11, Item 4," while 2024 IRC Table R302.6 requires separation on a wall between the dwelling unit and the garage of "Not less than 1/2-inch gypsum board or...
If the space in the garage attic is under 300-sf no requirement for attic access, If Two- car garage probable going to exceed that SF on a ranch garage with no rooms above the garage and will need an access. The main house would require an attic access for sure.
Hello, I wanted to see if I could get some help around codes for installing a ductless mini-split in my garage. I'm located in Corona, CA and the plan check manager told me: We adopted all 2016 Codes. California Plumbing, Mechanical, Electrical, Residential and Building Codes. I...
A garage to house man door cannot be used as part of an egress pathway; therefore, the IRC does not stipulate a minimum doorway width. That said, you should (IMHO) not do anything other than a 36-in door. The garage man door is typically a preferred location for moving things into the house. Not only during moving (think mattresses and other large furniture), but during the day-to-day ...
Typically when I draw a garage I just default to the portal frame since they're usually narrow in my area; not much meat on either side of the door. I have one coming up that is, for once, not. It's a 30x30, 11' ceilings, with a 14' door centered on the gable end. I'm having a hard time pointing...