S10forum is the community to discuss the S-Series, Chevrolet Colorado and GMC Canyon. Join to discuss rebuilds, modifications, tech articles and more!
I've searched many forums over the past couple of hours and have found nothing definitive. I'm trying to find accurate measurements of S10 axles, not "I think it's about xx inches wide." I need to know 2WD, 4WD and ZR2 widths from WMS to WMS. A guy has an 8.5 (or 8.625) with G80 from his ZR2...
S10 Rear end Ring Gear and Axle Sizes: 1983 to 1992 7.5" ring gear 26 spline axles Available from 1988+ 7.625" ring gear 28 spline axles Available from 1995 and up, 8.5" ring gear 30 spline axles, standard for 98+ ZR2's with rear discs These are some of the axle RPO codes and should be the same for all GMs with either of these axles. GU4=3.08 ...
This post is a compilation of parts, suggestions, tips, and practices to successfully swap an LS-based engine into an S10 Truck (2WD and Blazer variants) Most swappers generally underestimate the total costs and time for these conversions. Keep the engine bay clean. Once the original engine is...
If I could get an engine and gauge cluster diagram for my truck 2000 Sonoma 4.3 auto and my cousins (Lifted97s-10) 97 S10 4.3 auto it would be much appreciated. Trying to swap a newer ecm like mine into his truck so I can tune it and we keep running into wiring issues like fuel pump and fuel gauge that I cant track the wires down to. Thanks! V6zq8@sbcglobal.net
i wanna put 20's on my s10 (2000 X w/ belltech 2/3drop) and was wondering if i could just put the rims on with no problems with a 4.75 bs with 245/35/20 tires. I don't know too much about this so any helpful info would be appreciated.