Hi all - I've got a Stihl 025 that has become quite hard to pull-start. When I remove the spark plug, it's super easy. I've tried pulling it with the plug out to see if it was hydrolocked; I'm fairly sure it's not. I've noticed that it's considerably easier to pull with the switch in the "off"...
Howdy fellas, I found a Stihl FS 55R string trimmer on someone’s curb for free and trying to see if I can get it going. When I try to pull the rope to start it. It’s very hard. I removed the spark plug and it turns over very easily. Put the spark plug back in and hard to pull. Fuel tank was...
My MS290 had develop a condition where at times it is impossible to pull the recoil; as if the saw is locked up. This is when I try to pull fast to start the saw; you can pull the recoil slowly through each compression stage. Taking the plug out the saw pulls normally. I have been given a...
I saw a couple of you tube videos (from different people) who had bad comments about the Stihl HP Ultra 2 cycle oil. One of them concerned an insufficient amount of oil film in the crankcase. (That person fixes chainsaws). I have had a Stihl chainsaw go bad on me that had minimal hours on it...
Toggle signature Husqvarna, Ported 288 XP Lite, 372XPG, 357XP, 562XPG, OE 346XP, 346XP ported, Dolmar 7900, Ported JRed 2159, EchoCS300T, Stihl 028 Super completely rebuilt and ported Iron & Oak Commercial with log lift and hydro 4 way Silvey 510, Oregon 511AX and Tecomec grinders F250 Super Duty, 8' box and 10,000# trailer