from the thumb of Michigan I like old cartoons too. So much **** on TV these days. Vintage cartoons take me back and make me smile. Never heard "snort wagon" exactly. But it has a familiar and typical sound for the time. Might have likely come from Tex's imaginative mind. I had neighbors a couple of farms down the road. Lee and Norma, both 92 ...
What s the rule of thumb before cutting coils? Discussion in ' The Hokey Ass Message Board ' started by Garage Concepts, .
Just pull number on plug on the front left bank, pull coil wire to keep it from starting, stick your thumb over the hole, bump it slowly with your remote start button or a buddy on the key switch, when it blows against your thumb pull the cap and make sure the rotor is pointing at the number one hole, if it is not, like Jean Luc Piccard would ...
Roll oversteer feels twitchy. There are lots of "rules of thumb" about what should be parallel or pointing up or down. Mostly it's all bunk. Just do the calculations and design a geometry for the handling characteristics you want. Some adjustability is always a good thing as well.
What s the rule of thumb before cutting coils? | The H.A.M.B.
Technical Piston to wall clearance Discussion in ' The Hokey Ass Message Board ' started by Budget36, .
bendix brake conversion Discussion in ' The Hokey Ass Message Board ' started by dirt t, .
Rickybop ALLIANCE MEMBER from the thumb of Michigan Wow. Cool. I've got a thing for the old Mopar coupes. Love the '33 '34s. I think that's a Dana 60 rear end. 5 lug even. In fact, probably the same rear axle I just bought for my '31 from a '60s Ford truck.