too many arguments to function 'hw_timer_t* timerBegin (uint32_t)' 528 | timer = timerBegin (0, 80, true); // Alarm value will be in in us it looks like you are attempting to build code using ESP32 core 3.x which was implemented for ESP32 core 2.x have a look at the ESP32 core V3.x Arduino-ESP32 Timer API also worth looking at is Migration from ESP32 core 2.x to 3.x
The best way to answer this is to have you grab your favorite search engine and look for 'WDT RDP32 xxx,' where WDT stands for Watchdog Timer and xxx is the specific unit you have.
I clear the timer, set it up in Input Capture Mode, set the pre-scaler to ClkIO/1024, and enable Overflow interrupts, as the event I'm timing can take up to 10 seconds, which means the timer may overflow twice. I maintain a software count, in a uint32_t that is increment by 65536 every time an overflow occurs.
As you understand I need a hardware timer (counting clock ticks). Millis () makes demanding to ckeck if "old value" is smaller than millis () value (normal run from start until rollover) or greater (1st time after rollover) before any compare.
I'm posting here a simple project to create an interrupt timer on an ESP32 board for version 3.1.1 by Esspressif Systems. I had difficulties to find updated information to make this code, I hope it can be useful to someone ! This code creates an interrupt every 100ms and counts the number of interrupts. There is the code : #include "esp32-hal-timer.h" const int ledPin = 2; // pin of the LED ...